Proline MON22M38HPI User Manual (English)

Questions and Answers:

D
Daniel HughesAug 3, 2025
What to do if no image appears on my Proline Monitor?
- K
  Karen MezaAug 3, 2025
  If no image appears on your Proline Monitor, there might be a few reasons. First, ensure the power cord is correctly connected to the power outlet and that the monitor is turned on by pressing the Power button. If the display is in power saving mode, try moving the mouse or pressing any key on the keyboard. Also, verify that your PC is turned on. Check the signal cable between the PC and the monitor to ensure it is properly connected. If the signal from the PC is out of the display's frequency range, consult the 'Specifications' section of this manual to configure your display again.
B
beckjenniferAug 7, 2025
How to fix horizontal noise on Proline Monitor?
- M
  Michael BrooksAug 7, 2025
  To resolve horizontal noise or unclear characters on your Proline Monitor, start by pressing the AUTO button to automatically adjust the display image. If the issue persists, go to Control Panel ? Display ? Settings and adjust the display to the recommended resolution. You may also need to set the color setting higher than 24 bits (true color).
L
Leslie BennettAug 11, 2025
Why is my Proline MON22M38HPI Monitor screen color mono or abnormal?
- H
  harrisonkarenAug 11, 2025
  If your Proline Monitor screen color is mono or abnormal, first check if the signal cable is properly connected, tightening it with a screwdriver if necessary. Also, ensure that the video card is properly inserted in its slot. You may also need to set the color setting higher than 24 bits (true color) at Control Panel ? Settings.
M
Miguel CarterAug 16, 2025
What to do if vertical bars or stripes are visible on Proline MON22M38HPI Monitor?
- C
  Courtney TaylorAug 16, 2025
  If you see vertical bars or stripes on your Proline Monitor screen, try pressing the AUTO button. This will automatically adjust your display image to the ideal setting, which should resolve the issue.
S
Sonya GriffithAug 20, 2025
How to correct the display position on a Proline MON22M38HPI?
- T
  Terry BurchAug 20, 2025
  To correct an incorrect display position on your Proline Monitor, press the AUTO button. This will automatically adjust your display image to the ideal setting.
J
jacksonlindsayAug 25, 2025
How to stop the screen from blinking on my Proline Monitor?
- C
  Cindy MartinezAug 26, 2025
  To stop your Proline Monitor screen from blinking, check if the screen is set to interlace mode. If it is, change it to the recommended resolution.

Proline MON22M38HPI Specifications

General

Screen Size	21.5 inches
Response Time	5 ms
Contrast Ratio	1000:1
Brightness	250 cd/m²
Connectivity	VGA, HDMI
Refresh Rate	60 Hz
Aspect Ratio	16:9
Input Ports	1 x VGA, 1 x HDMI
Resolution	1920 x 1080
Viewing Angle	178° (H) / 178° (V)
Power Consumption	25W (Typical)

Proline MON22M38HPI User Manual

Table of Contents

Questions and Answers:

Proline MON22M38HPI Specifications