What to do if Proline I1000 displays code 3 and beeps?
If your Proline UPS displays the mode code '3' and you hear an alarm sounding with one beep every four seconds, it means the main power supply has failed, or the input power and/or frequency are out of tolerance. The system is automatically switching to battery mode. Check the input power source. If the problem continues, contact your dealer.
What to do if my Proline I1000 UPS is overloaded?
If your Proline UPS is overloaded, check the connected loads and remove any non-critical ones. Also, verify if any of the connected devices have failed.
Why does my Proline I1000 UPS show line voltage high?
If your Proline UPS indicates a line voltage high (OVCD action), it means the input power voltage is too high. The system will automatically switch to battery mode and will switch back to line mode automatically once the mains power returns to normal.
General| Capacity | 1000VA / 600W |
|---|---|
| Frequency | 50/60Hz |
| Communication Interface | USB |
| Operating Temperature | 0°C to 40°C |
| Operating Humidity | 90% non-condensing |
Important safety precautions to follow during the operation of the UPS unit.
Safety procedures for maintenance, servicing, and handling potential hazards.
Detailed guidance on connecting the UPS input power and output sockets.
Procedure for charging UPS batteries and turning on the unit.
Steps for connecting external batteries for extended runtime ('S' models).
Table of normal operating modes, warnings, and fault codes with their meanings.
Guide to identifying common UPS problems and their corresponding remedies.
To Next Page