Proliphix Thermostat - Ethernet Network Wiring

Beta Draft Confidential
8 Proliphix Thermostat Installation Guide, Release 1.0
Part No. 600-01000-100
Installing and Wiring the Thermostat
Table 3 lists the external sensor port Analog and Thermistor connections. Only one
sensor can be connected to each port.
Connecting CAT5/CAT5E/6 Wiring for Ethernet Networks
The label located on the inside of the base plate (see Figure 3) shows several
color-coded wiring schemes for Ethernet CAT5/CAT5E/6 connections.
To wire the Ethernet network, refer to Figure 3 and match the label number to the
Proliphix base plate number for CAT5/CAT5E/6 color coding.
Table 3 Remote Sensor Port Connections
Proliphix
Terminal
Analog Sensor
Thermistor Sensor
a
a
Do not connect either lead to the S1+, S2+ or S+ terminal when using a
Thermistor sensor.
S1+ Do Not Use or Do Not Use
S1- COM or Sensor 1, Either lead
S1 T20 or Sensor 1, Either lead
S2+ or S+ +V for S1 and S2 Do not use
S2- COM or Sensor 2, Either lead
S2 T20 or Sensor 2, Either lead
Note
If the other end of the CAT5/CAT5E/6 cable is connected to a Proliphix EPA-20/60
Ethernet Power Adapter, follow the wiring scheme for T568A.
Caution
All wiring must conform to local codes and ordinances. The distance between
CAT5/CAT5E/6 cables and HVAC cables should be a minimum of one inch.