ProLogic SNZ - SNZ Bite Alarm User Manual; Alarm Power On and Off; Volume Adjustment; Tone Selection

A new modern look and upgraded internal components have been used to provide
maximum reliability. The SNZ has all the features needed by modern carp angler: tone,
volume,sensitivityadjustmentandawidebutsubtlenightlightwiththreedifferentcongurations.
Supplied with plastic protective covers, available as a complete set with receiver or as single
units. The receiver has a built-in light that can be turned on and off manually.
SNZ BITE ALARM – USER MANUAL
• BATTERY TYPE (alarm and receiver): 9V (MN1604 / 6LR61 / PP3)
• BATTERY VOLTAGE: 9V
• STANDBY CURRENT: 0.04mA
• WORKING CURRENT: 80mA
• WIRELESS TRANSMISSION TYPE: AM
• RADIO TRANSMITTER FREQUENCY: 433.92MHz
ALARM
ON / OFF
To turn the alarm ON press and hold ' ' (6) button until you hear a sound signal.
3 seconds after this signal the alarm is ON.
To turn the alarm OFF repeat the same process until you hear another sound signal, now the
alarm is OFF.
VOLUME
In standby mode, turn ' V ' (7) dial roller to adjust the volume from level 0 (silent) to level 10
(loudest).
SELECT THE TONE
In standby mode, press ' T ' (6) to select your favourite of the 5 tone options.
ADJUST SENSITIVITY
In standby mode, turn ' S ' (3) to adjust the level of sensitivity. There are 5 different settings from
level 1 (maximum sensitivity), to level 5 (minimum sensitivity).
VISUAL BITE INDICATION
The SNZ alarm features a dedicated visual alert for both forward takes and drop back type bites,
allowingyoutoseewhichwaytheshistravellingbeforeyoulifttherod.Forforwardtakes,both
LEDs(1-5)willilluminate.Fordropbacks,therightLED(5)willashintermittently.
NIGHTLIGHT
In standby mode, press ' N ' (2) once to activate the 'auto night light' function. Press twice to
manually activate the night light function. Press three times to turn off the night light completely.
LOW BATTERY ALERT
When battery power is low, the alarm will sound 3 bleeps when switched on. Ensure battery is
replaced immediately to ensure complete functionality of the alarm. When battery power reaches
a critical level, the unit will beep at intervals of 1 minute until the battery is replaced.
ALARM
• Totally waterproof
• Operates with one 9V battery
(not included)
• Sensitivity adjustment with dial roller
• Volume adjustment with dial roller
• Silent mode
• 7 tone settings
• Night light function
• 100dB speaker
• Protective cover included
• Low battery alert
UK
Manuale SNZ Alarm.indd 4 30/06/16 16:55