Charging the battery
The RS7 battery can be charged three different ways. 1) By plugging the charging cord into the
wall-mounted tool caddy and hanging the vacuum on the caddy. 2) By plugging the charging cord directly
into the vacuum with the battery installed. 3) By removing the battery and charging it separately from
the vacuum.
If you are charging the battery while it is still attached to the vacuum, the LCD display will show battery
percentage. If you are charging the battery while it is removed from the vacuum, the LED lights on the
battery will indicate the charge level. Once all the lights are illuminated and no longer flashing, the
battery is fully charged. It is recommended to remove the battery from the charger once the battery is
fully charged.
To Next Page
Loading...
