Cleaning the Brush Roll
The EBK-250 power head has a built-in brush roll cleaner which helps you remove any built-up hair, string
or any other material which has wrapped around the brush roll. To use the cleaning tool simply slide it
out of its storage spot on the underside of the head. There is a hook and razor blade end; work the hook
under the built-up hair/material, run the blade through, then use your fingers to pull the hair and
material off and throw it in the trash. You may need to run the blade through a few times to completely
cut everything out.
WARNING: Always switch the appliance off and disconnect the battery before cleaning.
ATTENTION: Do not use cleaning or scouring agents or alcohol, as these might damage the appliance.
Clean the outside of the power head and other components using a slightly damp washcloth or
microfiber towel only. Wipe down with a dry towel or let air dry.
To Next Page
Loading...
