PROLYTE PRODUCTS GROUP © 2001
Prolyte has made every effort to ensure the accuracy of this manual, no liability will be accepted for errors. Prolyte reserves the right to change or alter
their products or manuals without prior notice. No part of this manual may be reproduced in any form or by any means without prior written permission.
PROLYTE PRODUCTS GROUP - phone +31 (0)594 85 15 15 - fax +31 (0)594 85 15 16 - www.prolyte.com
pages 2 of 12
Performance in aluminium
Manual-MPT Tower
The spans of the trusses must NEVER exceed permissible length or load values given in the
loading tables for the specic type of truss. MPT-towers are to be built to a maximum height
of 7,5m. The total weight on the tower including, load, sleeve block and trusses must NEVER
exceed 750 kg when using the hand winch or 1000 kg when using a chain hoist
1
.
Prolyte-MPT towers comply with the European Machine Directive and bear the CE-mark.
MPT-systems are designed for indoor use, for outdoor use please contact your local dealer or
Prolyte.
WARNING
Prolyte MPT-towers are not designed to lift people!
4. IDENTIFICATION
The MPT-tower is composed of the following parts:
1. Mast sections H30V 5,1 kg/m max. height 7,5 m
2. Base section MPT-004 26 kg made of steel hollow sections with castors
3. Sort outriggers MPT-011 2 kg short outriggers with screw jacks
Long outriggers MPT-012 12 kg long outriggers with screw jacks
Stabilizer tube T-51-PI094ST 1,5 kg
4. Top section MPT-009 11 kg Pulleys suited for 8mm steel wire or up to
8 mm chain links
5. Hinge set CCS6-H 2 kg 4 hinges per tower needed
6. Hand winch MPT-014 23 kg WLL 750 kg. Needs adapter for mounting.
Hand chain hoist MPT-015 24 kg WLL 1000 kg.
Electrical chain hoist CH-SM10-1004 45 kg WLL 1000 kg. Excluding chain.
Chain for hoist 1,6 kg/m1 Chain 6.8mm for hoist
7. Sleeve block MPT-010 44 kg Suitable to t all MP trusses and S36R/V
truss.
Optional components:
8. MPT-SAFE 14 kg Safety set to dead hang the sleeve blocks.
Per set 2 x MPR-009 and 2 clutches
(CH-07-200HCH).
9. Adapter for S36R/V MPT-A-S36R/V 6,3 kg Adapter Plate to connect S36R/V truss to
sleeve-block
The embossed ring on the ends of the conical coupler receivers, and stickers featuring the Prolyte logo
can clearly identify the MPT towers and truss.
NOTE
Make sure the system is built only of genuine Prolyte components, which are clearly and positively
identied as Prolyte products. Copies do exist, and even though they may appear to t to Prolyte
trusses, they do not have identical strength and safety characteristics.
1
In systems composed of two (2) towers or more, all lifting the same truss or grid, it is mandatory in Dutch Law to reduce the lifted load to 75% of
the rated capacity, thus max. 525 kg per tower with hand winch or max 750 kg per tower with 1 ton chain-hoist.
To Next Page
Loading...