You are required to pair Spire with your mobile phone once before using it.
• Switch on Spire and tap your NFC enabled smartphone on Spire.
• Your smartphone will then ask you whether you want to pair this Bluetooth®
device.
• Select “Yes” and Spire will then be connected to your smartphone.
Once Spire is successfully paired and connected with your mobile phone, you can
use it to make and receive calls. Spire can be used with voice dialing if your phone
supports the feature. Please consult your phone’s manual for more information.
• Using the phone keys to make a call: Dial a number on the phone as you normally
do. Once the call has been set up, the sound will be transmitted to Spire
automatically.
• Answering/Ending/Rejecting calls: When Spire is switched on and there is an
incoming call:
• Press the Multi-function button once to answer the call.
• Press the Multi-function button once to end the call.
• Long press the Multi-function button for 2 seconds to reject the call
• Put the call on hold. Press and hold the multi-function button for 2 seconds to put
the current call on hold and accept the call waiting. (The blue LED light flashes
with a prompt tone) Press the multi-function button twice again to resume to the
first call.
9. Make and receive calls
• Rotate your finger in a clockwise direction over the volume sensing area to
increase the volume of the speaker.
• Rotate your finger in an anti-clockwise direction over the volume sensing area to
decrease the volume of the speaker.
• Alternatively you may increase/decrease the volume by increasing/decreasing the
volume on your smartphone.
10. Adjust the volume
• Press the Multifunction button to Play or Pause you Music Track.
• Press the “Toggle Forward Button” to skip to the next track.
• Press the “Toggle Backward Button” to skip to the previous track.
• Alternatively you can skip to the next track by shaking the speaker from left to
right.
• To mute the track turn the speaker upside down.
To Next Page
Loading...
