Why is there insufficient vacuum in the bag with Promax DC-800 Packaging equipment?
Insufficient vacuum in the bag may occur if the bag is leaking, has been punctured by sharp corners on the wrapped product, or is simply too large. To resolve this, replace the bag. If sharp corners are the issue, replace the bag and use a thicker one. If the bag is too large, replace it with a smaller one.
How to fix burnt marks or bubbles on the sealing area of Promax DC-800 Packaging equipment?
Burnt marks or bubbles in the sealing area can be caused by oil, meat juice, dirt, or excessively long or high sealing time/temperature. Clean and remove any foreign substances from the sealing area. Then, adjust the sealing time or temperature to be shorter or lower.
What to do if a vacuum bag is easily pulled apart by hand after using Promax DC-800?
If a vacuum bag is easily pulled apart, the sealing time or temperature is likely too short or low. To fix this, adjust the sealing time or temperature to be longer or higher.
Why doesn't the vacuum pump run on my Promax Packaging equipment?
The vacuum pump may not run if the power supply does not match the power demand indicated on the back of the machine. Reconnect to the correct power source to resolve this.
What to do if the control panel is working but the vacuum pump won't start on Promax DC-800 Packaging equipment?
If the control panel functions normally but the vacuum pump does not start, the KM1, QM1, MCB1, or MCB2 protectors may be disconnected. Check each part and turn on the switch or reconnect if necessary.
General| Brand | Promax |
|---|---|
| Model | DC-800 |
| Category | Packaging equipment |
| Language | English |
To Next Page