Promax DC-800 - Setting the Parameters for the Optional Settings

10
Press the Right Arrow key to move to the next setting. The Soft Air LED will remain on.
However you are now setting the Vent Off time.
4. Using the Plus/Minus keys set the amount of time you want the vent valve to remain
closed between each vent pulse.
5. Press the Up Arrow key to return to normal operation mode.
3.4.2 Setting the Parameters for the Optional Settings
ImportantNote: Thesesettingswillonlyfunctioniftheoptionstheypertaintowerepurchased.
Refertofigure6belowtohelpyoucompletethesesettings.



Figure 6
PRO G RA M
PROGRAM TI ME / %
SK IP
CYCLE
STO P
CYCLE
STB
W ORK VAC
GAS
SEAL1 SEAL2
COOL SO FT GAS
SH IFT
GAS
ON/OFF
PU LSE
ON/OFF
O IL CHG
AIR
ON/OFF
PU LSE
PU R G E
PO W
ER ON
PO W
ER OFF

Gas On / Off /Pulse LED
Purge Gas On / Off Pulse On / Off
A. Gas Flush
1. Prepare to make changes as instructed in point D
2. Press the Left Arrow key until the Gas LED is lit.
3. Using the Plus /. Minus keys set the amount of time you want gas to enter the
chamber.