promethean ACTIVTABLE - Troubleshooting

20 ActivTable Quick Start Guide
If the power lead is disconnected the following occurs:
•
The ActivTable emits a steady beeping noise for twenty seconds and the On button ashes Blue.
•
The user has a further twenty seconds to reconnect the power. The On button continues to ash Blue but does not beep.
If the power is reconnected the ActivTable returns to normal operation.
•
The ActivTable begins shut down if the power is not reconnected.
•
During the shut down procedure the On button is a continuous Yellow.
•
When shut down is complete the On button light goes off.
If the ActivTable doesn’t power up when the On button is pressed, check the following:
•
If the On button briey ashes Blue then the button has not been pressed for long enough.
•
If the On button briey ashes Red, then the ActivTable cannot detect mains power.
•
The power is switched on at the electrical outlet.
•
The power plug is correctly inserted into the electrical outlet.
•
The power cable is correctly attached to the leg of the ActivTable
Power Lead Disconnected
ActivTable Will Not Power Up
Troubleshooting