Power amplifier TL series
2022-11-21 Pronomic TL Serie / ArtNr.: 00063864/00021732/00021733/00021734 9
STEREO (2-CHANNEL) – MODE
1. Check if the power amplifier is switched off.
2. Set the MODE SELECTION SWITCH (16, on the back of the unit) to the middle
position "STEREO".
3. Connect the input / output lines properly as shown in the illustration above.
PARALLEL (MONO) –MODE
Do not use the "PARALLEL (MONO)" setting when feeding the
separate signals from another power amplifier.
1. Check if the power amplifier is switched off.
2. Set the MODE SELECTOR (16, on the back of the device) to the "PARALLEL"
position. The input signal from CH-1 is passed on to the input of CH-2.
3. Connect the input / output lines properly as shown in the illustration above.
To Next Page
