Pronomic TL 200 - Page 12

Power amplifier TL series
10 Pronomic TL Serie / ArtNr.: 00063864/00021732/00021733/00021734 2022-11-21
BRIDGED (MONO) – MODE
Make sure that the cabling and the loudspeaker used are
suitable for this.
1. Check if the power amplifier is switched off.
2. Set the MODE SELECTION SWITCH (16, on the back of the unit) to the
position "BRIDGED".
3. Connect the input / output lines properly as shown in the illustration above.
The signal will be output in CH-1.
4. Turn the volume control of channel "2" counterclockwise until it stops.