03. Backrest Assembly
04. Canopy Assembly
① The backrest with the extra buckle on top attaches by the front wheels and the backrest without the extra buckle on top attaches towards the
back wheels.
② Attach the zipper on the bottom of the backrests to the receiving zipper on the bottom of the bassinet.
③ Pull the buckle strap, on the back of the backrest, through the correlating hole on the fabric of the bassinet. Pull the strap through and buckle
the backrest strap to the buckle on the outside of the bassinet like picture ④
⑤ Maneuver and insert the seat belt clip into the hole on the floor of the bassinet.
Pull it out through the underside of the bassinet and affix like picture ⑥
① Insert the buckles of the canopy frame to the receiving brackets located below the handle bar.
② Slide the fabric of the canopy hood onto the canopy frame as pictured above in ② and ③
④ Press the silver ball on the main canopy frame and slide the canopy hood frame onto the main frame as pictured in ④
⑤ Adjoin the zippers on the main canopy fabric with the hood fabric, completing the canopy assembly.
Assembly
5
8
Warning! Use after properly installing the front and rear backrests.
① ② ③
④ ⑤ ⑥
Front wheel side Back wheel side
① ② ③
④ ⑤ ⑥
To Next Page
Loading...