Tyee – specification
PROPAIN’s Tyee is a Enduro Bike. Please find the according cate-
gory in the “user handbook bicycles” which is included in your bike
delivery. Be sure to use your bicycle only according to the “intended
use” specified by the category.
If you replace parts of your bicycle, please pay special attention to
the hardware compatibility. If in doubt, please contact Propain or
your local bike dealer.
The Tyee has the following specifications:
Maximum front travel allowed: 170mm
Rear travel: 160mm
145mm, Tyee All-
Mountain
Shock length: 210mm
Shock travel: 55mm
50mm, Tyee All-
Mountain
Shock mount top and bottom: 8mm x 20mm (top),
30mm (bottom)
Bottom bracket: 73mm BSA
Break mount: Post Mount 180
Seat post diameter: 31,6mm
Headset: Tapered – Top: IS42 /
Bottom: IS52
Rear wheel axle: 148mm Syntace X12
Chain line: 52mm (Boost)
Chain guide mount: ISCG05
Recommended tire size: 650B (27,5“)
Tightening torque
The mounting bolts of the frame and suspension have to be tight-
ened according to the table below. After untightening any bolts
Propain recommends using Loctite 243 (medium) before tightening
the bolts again. Please also consider the drying time of Loctite.
Suspension
To Next Page
Loading...
