number of the SAG indicator that is visible on most of the recent
shock’s pistons.
To adjust the SAG, please change the air pressure. Before meas-
uring the SAG again compress the shock several times to make
sure the pressure has distributed into all air chambers inside the
shock.
In addition to the according SAG adjustments, the compression
speed has to be dampened to avoid a “bottom out”. To adjust this
setting turn the screw or lever on your damper saying “compression”
or “high speed compression”. If you experience “bottom out” with
your setting increase the compression damping.
“Bottoming out” your suspension can lead to damage of the frame,
parts and / or the shock.
If you are uncertain in any of the points mentioned above, please
do not hesitate contacting Propain or your local bike dealer.
Fork
Forks with up to 170mm of travel are approved to be used with the
Tyee. A fork length of more than 564mm must not be used as it
leads to forces on the frame for which it was not approved. The fork
length is measured from the middle of the front axle to the top of the
crown.
In the worst case, the use of a too long fork could result
in a crack or damage of the frame while riding the bike.
This could cause a crash and / or severe injuries. The
warranty claim expires under these circumstances.
Fork maintenance
Permanent excellent fork performance can only be guaranteed if it
is serviced periodically. To ensure that you should keep a few things
in mind:
Clean the running surface of the fork after every ride, especially in
extremely dusty or muddy conditions. Lubricate the seal at the pis-
ton rods according to the manufacturer’s instructions.
If you are uncertain in any of the points mentioned above, please
do not hesitate contacting Propain or your local bike dealer.
To Next Page
Loading...
