38
▪ Mow across slopes, not up and down. If mowing a slope, start at bottom and work
upwards to ensure turns are made uphill.
▪ Do not mow at a high ground speed, especially if a mulch kit (available
separately) is installed.
▪ Do not cut the grass too short. Short grass is prone to weed growth and yellows
quickly during dry weather.
▪ For the best results, it is recommended that the first two laps be cut aiming the
thrown discharge towards the center of the lawn. After completing the two laps,
reversed the direction to throw the discharge to the outside for the balance of the
cutting. This will give a better appearance to the lawn.
▪ Do not attempt to mow heavy brush, weeds, or extremely tall grass. Your mower is
designed to mow lawns, not to clear brush.
▪ Keep the blade(s) sharp and replace or sharpen when worn. Dull blades will
reduce battery run time.
MOWER DECK HEIGHT SETTING AND USE
Make certain that the area to be mowed is free of debris, sticks, stones,
wire, or other objects that can be thrown by the rotating blades.
When the battery charge gets too low, the blades will automatically disengage
and stop. When this situation occurs the mower should be plugged into the charger as
soon as possible.
If the mower stops, or the blades stop, or the speed of the mower reduces, and
the buzzer emits a sound (the sound typically continues for one minute), referred to the
Troubleshooting section of this manual.
1. Adjust the Mower Deck to the desired cutting height by moving the Deck Lift
Handle to the left and placing it in the notch that is best suited for your
application.
2. Engage the blades by pulling up on the Blade Start / Stop Knob (PTO). Use the Low
Cutting Speed Button on the Right Hand Console to select either the Blades
Normal or Blades Boost speed functions, depending on the conditions.
3. On the first pass, pick a point on the opposite side of the area to be mowed and
maintain a straight line towards that point.
4. Slowly press the Forward Drive Pedal forward until the desired speed is achieved
and steer the mower straight towards the alignment point.
To Next Page
Loading...
