PRORUN PRM48V38 - Page 41

41
2. Stop the mower, disengage the blades, set the Parking Brake Handle, and turn the
Key Switch to the OFF position.
3. Thread the hose coupler onto the end of your garden hose.
4. Attach the hose coupler to the Smart Jet System’s water port located on the left
top surface of the mower’s cutting deck.
5. Turn the water on.
6. While sitting in the operator's position, start the mower as instructed beginning on
page 30.
7. Engage the blades.
8. Remain in the operator’s position with the cutting deck’s blades engaged for a
minimum of two minutes, allowing the underside of the cutting deck to
thoroughly rinse.
9. Disengage the blades.
10. Turn the Key Switch to the OFF position to turn off the mower.
11. Turn the water off and detach the hose coupler from the Smart Jet System’s
water port on the cutting deck’s top surface.
12. After cleaning your cutting deck with the Smart Jet System, return to the
operator's position, start the mower, and engage the blades. Keep the cutting
deck running for a minimum of two minutes allowing the underside of the cutting
deck to thoroughly dry.
CUTTING SUGGESTIONS
The machine is not suitable for heavy-duty work and for mowing large
quantities of grass.
1. When adjusting the cutting height and machine speed, be careful not to
overstress the machine.
2. For problem-free use, the cutting height and the movement speed must be
adapted to the height of the grass to be cut.
3. On particularly rough surfaces, work with greater cutting height to prevent the
blade knocking against any surface irregularities, resulting damage to the blade
and mechanical parts.
OPERATING TIMES AND DAYS
The time of operation of the lawnmower could be regulated by specific national or
local laws. Contract the local authorities for more information.