40
END OF MOWING
When You Have Finished Mowing:
1. Operate the parking brake.
2. Disengage blade rotation.
3. Lift the blade deck up as far as it will go.
4. Drive the machine to your destination.
Always remove the ignition Key (15) before leaving the machine
unattended! To keep the battery charged, do not leave the ignition Key (15) in the ON
position when the engine is not running.
CLEANING THE MACHINE
A brush, damp sponge, or rag should be used to clean the mower. Do not use high
pressure nozzles or aggressive liquids to wash the casing and the motors.
do not spray water into the battery compartment when cleaning the mower.
Doing so can cause serious damage to the mower’s electrical system.
To clean the battery cover, the seat must be positioned all the way back and
tilted up to allow access to the area under the seat.
CLEANING THE DECK
Your mower is equipped with a water
port on the top surface of its cutting
deck. Attach a garden hose and use
the Smart Jet System to rinse grass
clippings from the deck’s underside
and prevent buildup of corrosive
chemicals.
Complete The Following Steps After Each Mowing:
1. Drive the mower to a level clear location on your lawn, close enough for your
garden hose to reach.
While relocating your mower, make certain that the mowers discharge
chute is directed away from your house, garage, parked car, etc.
To Next Page
Loading...
