EasyManua.ls Logo

PRORUN PRM48V38 - Page 48

PRORUN PRM48V38
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
48
The Safety Switch located on the left side of the Charging Port is a part
of the Safety Interlock System. The power of the mower will disengage with opening of
the Charging Port Cover.
CHARGER MODEL WT4808PNG/ WT4808PMG:
INPUT: 100-240V, 50/60Hz, Max. 4.5A / OUTPUT: 48Vd.c 8A
The batteries must only be charged in an area protected against poor weather
conditions in the shade at a recommended temperature of between 32° to 95° F
(0° to 35° C).
The batteries are equipped with a protection device that inhibits recharging if the
environmental temperature is not between 32° to 113° F (0° to 45° C).
BATTERY CHARGING TIPS
Use only the Battery Charger provided with this mower.
The batteries should be fully charged before each use.
It is recommended that the mower batteries are charged once every month
during off-season storage.
It will take approximately 10 hours to fully charge the batteries
Leaving the batteries connected to the Battery Charger for more than 10 hours will
not damage the batteries.
The batteries do not develop a memory and do not need to be fully discharged
before recharging.
Always disconnect the Battery Charger (or extension cord, if used) from the
electrical outlet first, then disconnect the Charging Cord from the Charging Port.
It is recommended that the mower be charged after every use. Storing batteries
in a discharge state could reduce future performance.

Other manuals for PRORUN PRM48V38