PRORUN PRM48V38 - Page 55

55
PROBLEM
POSSIBLE CAUSE
REMEDY
Mower
stopped or
will not
start.
1. Reset.
2. Hub fault.
3. Operator Presence Switch
fault.
4. Over-voltage.
5. Pre-charge failure.
6. Hub communication
failure.
7. Left cutting deck
communication failure.
8. Right cutting deck
communication failure.
9. Contactor tips welded
closed.
10. Self-test failure.
11. Operator Presence Switch
Contactor tip failure.
12. Battery charger plugged
in.
1. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
2. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
3. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
4. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
5. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
6. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
7. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
8. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
9. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
10. Shut off and restart mower. If the
problem persists contact PRORUN
Customer Service.
11. Check to see if Operator Presence Switch
is plugged in. Shut off and restart mower. If
the problem persists contact PRORUN
Customer Service.
12. Unplug charger and return to the start-
up prompt.