Using the remote control
< Inserting the batteries into the remote control >1 .Push the back of the remote control and )utl forward stightty.2.1nsert two
AAA 15V batteries ensuring the correct polarity (+/-).3.Close the lid.
inserting the batteries
Caution: Use only Alkaline Batteries.
• If the remote control is not working, see the checkpoints below.
• Are the polarities of the batteries (+, -) correct?
• Are the batteries worn out?
• Is there an AC power failure?
• Is the power cable plugged in?
• Is any special fluorescent or neon sign board turned on?
< Remote Control Reception Angle>
Use the Remote control within a range of 7~10m and at an angle of 30': to either side of the receiver.
Remote Control TV Angle
Caution-Used batteries should be recycled and kept out of children's reach.-Do NOT use new and old batteries together.
Change both batteries at the same time.
-When not using the remote control over a long time, remove the batteries from the unit. Use only Alkaline batteries
13
To Next Page
Loading...
