4
Attach Thermostat to Sub-Base
5
1. Line up the thermostat body with the sub-base.
2. Carefully push the thermostat body against the sub-base until it snaps
into place.
3. Insert quick reference card into slot on top of thermostat.
3
Setting User Options
Advanced User Options
User options allow you to customize some of your thermostat’s features.
Most users will not need to make any changes to the settings in this section.
To enter the User Options menu, hold down the RETURN button
for
approximately 3 seconds until the screen changes and displays the
first User Option.
Press the or button to change the setting for the
displayed User Option.
After you have made your desired setting, press
RETURN to advance to the next User Option. The thermostat will return to
normal mode after your last user option is made or after no keys have been
pressed for 15 seconds.
Table of User Options
User Factory Setting
No. Options Default Options Comments
1
Programming
PRO 7 PRO 7
Select for 7 Day Programming Mode
Mode PRO 52 Select for 5-2 Day Programming Mode
PRO NO Select for Non-Programmable Mode
2
1st stage
0.5
0.5, 1.0,
Select a 1st stage temperature
differential
2.0 differential of .5˚, 1˚ or 2˚F (0.2˚,
0.5˚ or 1˚C)
3
2nd stage
2.0
1.0, 2.0,
Select a 2nd temperature
differential
3.0, 4.0
, differential of 1˚, 2˚, 3˚, 4˚, 5˚ or 6˚F
(PRS4210 Only)
5.0, 6.0
(.5˚, 1˚, 1.5˚, 2˚, 2.5˚ or 3˚C)
LNG
Selects long (permanent) hold mode
24HRS
Selects 24 hr. (temporary) hold mode
5
OFF
Disables filter service monitor feature
30, 60, 90
, Selects a number of days before
120, 180, the thermostat will flash a Service
365 Filter reminder in the display.
6 OF REC Disables adaptive (early)
recovery mode
ON REC Enables adaptive (early)
recovery mode
Extended
Hold Period
Filter
Service
Monitor
LNG
Adaptive
Recovery
Mode(ARM
TM
)
OF REC
OFF
4
4
Setting Your Program Schedule
Setting the Time and Day
1.
In normal operating mode, press the DAY/TIME
button. The display will switch to the day/time
setting mode and the hour will be flashing.
2. Press or to adjust the hour.
Press DAY/TIME.
3. Press or to adjust the minute.
Press DAY/TIME.
4. Press or to adjust the day of the week. Press RETURN to exit.
To Next Page
Loading...
Need help?
General
