FUNCTIONS
Autoranging/
Manual
• The meter’s default setting is autoranging. This
automatically selects the best range for the selected
test/measurement.
• To set the meter to manual, press the “RANGE”
button. The AUTO icon on the screen will turn off.
• Press the “RANGE” button to move through the
available ranges until you see the range you want.
• To exit the manual mode and return to
autoranging, press and hold the “RANGE” button
for 2 seconds.
• Manual ranging cannot be selected for capacitance
and frequency measurements.
Mode • The “MODE” button helps you to move through
various operations with various icons displayed on
screen.
• It works in conjunction with the function switch to
measure things like resistance, diode, continuity and
capacitance.
• It also allows you to select between AC or DC
current measurements.
Function
Switch
• Select a measurement range by turning the switch
to the preferred option.
LCD Screen • Readings and measurements taken by the
multimeter will display in this area.
Hold &
Backlight
• Press the “HOLD” button to lock readings as
displayed on the screen. Press again to unlock.
• Press the “HOLD” button longer to turn the
backlight on. Press the button longer again to turn
the backlight off.
Relative
Button
• Press the “REL” button to store a reading for
referencing at a later date. Then reference any new
inputs against the stored measurement.
• Press the “REL” button again to cancel the relative
measurement function.
• Not to be used for Hz/duty, diode and continuity
measurements.
5
To Next Page
Loading...
