Protect 600i - Page 2

• What must be secured – which valuables? ✔
• Where are the valuables to be secured? ✔
• The design of the room/rooms ✔
• Full coverage ✔
• Point/partial protection? ✔
• The intruders expected actions ✔
• Critical seconds/primary and secondary area ✔
• Fog deployment time in seconds ✔
• Position – Ceiling Mounting – Wall Mounting ✔
• Amount of fog needed ✔
• Choice of machine/machines ✔
• Activation type/types ✔
Dimensioning, Specification
and Positioning - CHECKLIST
DIMENSIONING - CHECKLIST
INSTALLATIONS RECOMENDATION
POINT PROTECTION
FULL PROTECTION
REMEMBER!
Heating time =
Time without coverage.
• PROTECT FOQUS = 7 min.
• PROTECT QUMULUS = 8-10 min.
• PROTECT Xtratus = 8 min.
• PROTECT 600i = 10-15 min.
• PROTECT 1100i = 15-25 min.
• PROTECT 2200i = 30-45 min.
If the heating time is considered too
long, it is recommended to keep the
machine constantly heated.
Point protection in shop
Full protection in shop
Point protection in warehouse
Full protection in shop
HEATING TIME
GOOD INSTALLATION/DEMO BAD INSTALLATION/DEMO
REMEMBER!
Reheating time after deployment of
fog - for full capacity.
• PROTECT FOQUS = 0,5-3 min.
• PROTECT QUMULUS = 0-5 min.
• PROTECT Xtratus = 0-5 min.
• PROTECT 600i = 0-5 min.
• PROTECT 1100i = 0-8 min.
• PROTECT 2200i = 0-14 min.
REHEATING TIME
1. 2.
3. 4.
1
Seen from above Seen from above
Min. 2,5 m.
Min. 2,5 m.
35 cm
1. 1.
3. 3.
2. 2.
4. 4.