Protek B-810 - Installation; Installation Introduction; Preparation for Use

rp‘
SECTION
II
INSTALLATION
1 . INTRODUCTION
This
section
provides
installation
instructions
with
this
Sweep
Function
Generator.
Th;
section
also
includes
information
on
preparation
for
using
the
Sweep
Function
Generator
an
storage.
Z. PREPARATION FOR USE
1 ) Power Requirements.
This
Sweep
Function’Generator
requires
a
power
source
of
100,
120,
220
Volts
ac
:l:
10%
or 240 Volts ac zi: 5% — 10%, 48 to 66H: single phase.
WARNING
IF
THIS
INSTRUMENT
IS
TO
BE
ENERGIZED
VIA
AN
EXTERNAL
AUTO
TRANSFORMER
FOR
VOLTAGE
REDUCTION,
BE
SURE
THAT
THE
COMMON
TERMINAL
IS
CONNECTED
TO THE NEUTRAL POLE OF THE POWER SUPPLY.
2)
Line
Voltage
and
Fuse
Selection
CAUTION
BEFORE TURNING THE SWEEP FUNCTION GENERATOR LINE SWITCH TO ON. VERIFY
THAT THE INSTRUMENT IS SET TO THE VOLTAGE OF THE POWER SUPPLIED.
Figure
2-1
provides
instructions
for
line
voltage
and
fuse
selection.
The
line
voltage
selection
and
the
proper
fuse
are
factory
installed
for
the
voltage
appropriate
to
instrument
destination.
CAUTION
USE PROPER FUSE FOR LINE VOLTAGE SELECTED.
“W.
..
M.“
"a.