OPERATION: FLYING THE HELICOPTER
7
TAKE–OFF:
1. From idle mode, press the take off button or gently advance the throttle up to
a desired height and release. The helicopter will hover at that height.*
LANDING:
1. Press the land button and the helicopter will automatically land.
2. Push down on the throttle until the helicopter is on the ground.
NOTE:
* Emergency Stop: Press and hold
to immediately stop the engine.
* The helicopter may drift a bit, especially in the first 30 seconds until
the altitude sensor gets a good fix on the position. Some drift is normal.
TAKE-OFF BUTTON
LANDING BUTTON
To Next Page
Loading...
