Proton X70 2021 - Lamps; Wiper and Washer

Wiper and WasherLamps
19 20
Front wiper - Si
ngle wiping
Pull and release wiper control handle along B
direction (the handle returns to O position), the
front wiper will performone one wiping cycle.
Front wiper - Turn OFF
The wiper control handle is at O position and
the front wiper will be turned off.
Front wiper - Automatic wiping
Pull the wiper
control handle to AUTO position
along the A direction to set the automatic
wiping.The system will adjust the wiping speed
according to sensitivity of the rain sensor.
The sensitivity of the rain sensor can be
adjusted by turning the knob at the end of the
wiper control handle.
If the mark is pointed from to (C direction),
the sensitivity of the rain sensor will change
from weak to strong.
Wiping of rear wiper
Press for intermittent wiping of rear wiper,
press
for continuous wiping of rear wiper.
Press the 0 (middle) position to stop the wiping
of rear wiper. Reversing automatic function
of the rear wiper, when the front wiper is
operating (intermittent, low speed, high
speed), shift to gear R and the rear wiper
enters intermittent mode automatically.
A
C
B
Lamp control switch
0 : OFF
: Position lamp
: Low beam
AUTO : Automatic lamplight
Turn the lamp control switch to corresponding
position to ac
tivate their functions.
Fog lamp control switch
Front fog lamp
Press
when the position lamp is turned on,
Rear fog lamp
Press when the front fog lamp is turned
on or low beam lamps are on, and will be turned off
19
Rain sensor
Rain sensor
Rain sensor is located at the above of the interior
rearview mirror.
Lamplight
control switch
Fog lamp
control switch
Lamplight switch handle
Light Control Combination Switch:
High beam
To use the high beam, press the lamplight control
switch to the front after the low beam is turned on.
High beam lamp flashing
The headlamp flashes each time you pull the
lamplight switch handle towards you.
Turn signal lamp
Push the lamplight switch handle up or down when
you make a turn to the left and right respectively.
Follow me home
When the vehicle alarm system (anti-theft) is
inactive and within 10 minutes after you turn the
ignition from ON/ACC to OFF position, open the
driver’s door for the first time to activate the
Follow Me Home lamp.
Refer to the Owner’s Manual for details.
Wiper Control Combination Switch:
and will be turned off if this switch
is pressed again.
if rear fog lamp switch
is pressed again.