ORiNOCO
®
802.11n Access Points - Software Management Guide 101
3. Click Retrieve.
: When the device is operational with factory default settings, there is no Config file present and hence it cannot be
retrieved.
File Type Specifies the file type that you want to retrieve from the device. To configure, select any of
the following File Type from the drop down menu.
– Config: Specifies the configuration files of the device.
– Event Log: Specifies the Event Logs from the device.
– Text Based Template Config: Specifies the Text Based Template Configuration
(TBC) files of the device. TBC template can be used to configure the parameters and
retrieve the configuration to the device.
– Config Profile: The Config Profile is used to replicate the configuration of a master
device on similar devices. While replicating, you have an option to exclude unique
device’s parameters such as System information, IP configuration, Ethernet
configuration and Wireless configuration. By default, System Information and IP
Configuration parameters are excluded.
Select Config Profile from the File Type.
Figure 6-14 Retrieve Config Profile File via TFTP
Select the parameters to exclude and click Create Profile. Next, click Retrieve.
See Update Configuration, to update the target device with the retrieved config
profile. Once updated, the target device comes up with the configuration of the
master device, by excluding the selected unique parameters.
: Config Profile is applicable only to the compatible devices.
To Next Page
Loading...
Need help?
General
