ORiNOCO
®
802.11n Access Points - Software Management Guide 102
6.2.3.3 Text Based Configuration (TBC) File Management
Text Based Configuration (TBC) file is a simple text file that holds device template configurations. The device supports the TBC
file in XML format which can be edited in any XML or text editors. You can generate the TBC file from the CLI session and
manually edit the configurations and then load the edited TBC file onto the device so that the edited configurations are
applied onto the device. It differs mainly from the binary configuration file in terms of manual edition of configurations. The
generated TBC file is a template which has only the default and modified configurations on the live CLI session.
1. Generating TBC File
The TBC file is generated through CLI by executing generate command. While generating the TBC file from CLI, there is an
option to generate it with or without all the Management and Security passwords. The management passwords include
CLI/WEB/SNMP passwords. The security passwords include Network-Secret/Encryption-Key(s)/RADIUS-Shared-Secret. If
included, these passwords become a part of the generated TBC file and are in a readable format. If excluded, all these
passwords are not part of the generated TBC file.
The commands used for the generation of TBC file are:
AP-00:7D:09>enable
AP-00:7D:09# generate ?
Possible completions:
tbc-with-pwds Generate Text Based Template Config file with keys/passwords
tbc-without-pwds Generate Text Based Template Config file without keys/passwords
The generated TBC file contains,
• Default configurations.
• Any user-added or edited configurations on current live CLI session.
The generated Text Based Template Configuration file appears as shown below:
Figure 6-15 TBC File in XML Format
To Next Page
Loading...
Need help?
General
