- 11 -
Translation of the Original
Operating Instructions
PROXXON WP/E Angle
Polisher
Dear customer!
Always keep these operating instructions and the
enclosed safety guidelines within reach.
Only use this device with exact knowledge of it and
comply with the instructions and safety guidelines!
This is necessary to ensure safe operation and, sec-
ondly, it facilitates familiarisation with the device and
its functions.
Proxxon assumes no liability for the safe function of the
device in the case of:
• handling that does not comply with normal intended
use,
• use for other purposes not mentioned in the manual,
• incorrectly executed repairs,
• failure to heed safety instructions,
• external effects for which the manufacturer is not
responsible.
We recommend using PROXXON original spare parts for
all repair and maintenance work.
Repairs should only be performed by qualified skilled
personnel!
Please note: All information contained in these operating
instructions - especially the technical data - corresponds
to the status at the time of printing.
We reserve the right to make further developments in
the interest of technical progress. We wish you every
success with the device.
WARNING!
Read all safety warnings and instructions.
Failure to follow all safety warnings and
instructions listed below may result in electric shock,
fire and/or serious injury.
KEEP ALL SAFETY WARNINGS AND INSTRUCTIONS FOR
THE FUTURE !
Safety Warnings Common for Grinding, Sanding,
Wire Brushing, Polishing or Abrasive Cutting-Off
O
perations:
a.) This power tool is intended to function as
a
sander or polisher. Failure to follow instruc-
tions listed below may result in electric shock,
fire and/or serious injuries.
b.) This electric power tool is not suitable for
grinding, wire brushing and cutting-off oper-
ations. Uses for which the power tool is not
intended can cause hazards and injuries.
c.) Do not use accessories which are not
designed or recommended by the manufac-
turer specifically for this power tool. Just
because the accessory can be attached to your
power tool does not assure safe use.
d.) The rated speed of the bits and cutters must
be at least equal to the maximum speed
specified on the power tool. Accessories that
turn faster than their rated speed can break and
fly apart.
e.) The outside diameter and thickness of the
bits and cutters must be within the capacity
rating of your power tool. Incorrectly sized
bits and cutters cannot be adequately guarded
or controlled.
f.) The arbour size of discs, flanges, grinding
discs or other accessories must properly fit
the grinding spindle of your power tool. Bits
and cutters that do not fit the grinding spindle
of the power tool properly will turn unevenly,
vibrate very strongly and cause loss of control.
g.) Do not use damaged bits and cutters. Before
each use, inspect bits and cutters such as
sanding discs for chips and cracks, grinding
discs for cracks, strong wear or tear, wire
brushes for loose or broken wires. If the
power tool or bits and cutters are dropped,
check for damage or install undamaged bits
and cutters. After you have inspected and
installed the bits and cutters, keep yourself
and any other persons in the vicinity away
from the plane of the rotating bits and cutters
and run the device at maximum rotational
speed for one minute. Damaged bits and cut-
ters usually break during this test time.
GB
To Next Page
Loading...
