- 14 -
6 Working with the device:
• Never work without dust protection mask and safety
glasses. Some dusts have a hazardous effect! Mate-
rials containing asbestos may not be machined!
• Do not work with damaged tools!
• Ensure the work piece is fixed securely! Loose work
pieces should be clamped in a suitable fixture. This
prevents the work pieces from flying about.
• A correct and uniform speed achieves a high perfor-
mance, not excessive contact pressure! Excessive
pressure is to be avoided: it only stresses the device
4
Technical data:
Motor:
Voltage: 230 V, 50/60 Hz, ~
Power: 100 Watt
Short-term operation: KB 3 min
Device:
Length: approx. 260 mm
Weight
(incl. connecting cable): approx. 880 gr.
Spindle velocity: 800-2500 rpm
Maximum polishing tool
diameter: 50 mm
Noise development: < 70 dB(A)
Please note that the sound and vibration measurements
in particular have been performed with Proxxon bits
and cutters. When using third-party brands we cannot
guarantee compliance with the statements given here!
5
Commissioning
Your WP/E angle polisher is delivered ready for use and,
except for the fitting of polishing tools to the rubber
backing disc, no special commissioning measures need
to be taken.
However, please check the device and the polishing
tools for any visible wear before every use!
Always ensure your own safety!
Despite its compact size, the WP/E angle polisher is an
electric tool that harbours a certain level of risk. Always
ensure that the mains plug is disconnected when
checking the device, during cleaning or when changing
polishing tools!
5.1 Rubber backing disc with quick-action touch
fastener (Fig. 2)
Polishing tools 1 (e.g. the polishing sponge or felt disc)
are fixed to the rubber backing disc 3 with the touch
fastener 2. Rapid and safe changing of polishing tools
therefore poses no problem when adjusting to different
materials or machining stages. When changing a pol-
ishing tool, simply pull of the tool and press on the
replacement!
The following polishing tools are included in the scope of delivery of the WP/E angle polisher:
A microfibre cloth (Article 28678) is also included with the WP/E for final cleaning of polished surfaces.
1 x Polishing sponge
(blue=medium
hard, Article 28662)
For applying polishing emulsion to paint and metal surfaces and
subsequent polishing. With touch fastener.
Ø 50 x 25 mm.
1 x Lambskin polishing
hood
(Article 28664)
Made of high-quality, thick lambskin for polishing scratchproof
paints. With touch fastener. Ø 50 mm.
1 x Polishing felt disc,
medium hard
(Article 28666)
For polishing metals (e.g. stainless steel, brass and copper).
With touch fastener.
12 x Super-fine grinding
disc, 2000 grit
(Article 28670)
Made of silicon carbide. For finishing of paint surfaces, removing
paint drips and inclusions. With touch fastener. Ø 50 mm.
To Next Page
Loading...
