- 16 -
A
new rubber backing disc is available commercially
u
nder the article number 28548.
1. Press the lock button 1 carefully.
2. Using a suitable screwdriver, release and unscrew
the check screw 2. Caution: The shaft may rotate as
well somewhat until the lock button “finds” its cor-
rect position on the shaft in the interior of the
device. This is noticeable when the lock button
engages completely at that point. The shaft is then
blocked.
3. Remove the rubber backing disc 4 and the disc 3.
4. Replace the rubber backing disc 4.
5. Fit the screw 2 and disc 3.
6. Tighten the screw 2 firmly.
9 Disposal:
Please do not dispose of this machine in household
refuse! The device contains reusable materials which
can be recycled. If you have any questions about this,
please contact your local disposal company or other
appropriate local facilities.
EC Declaration of Conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation: WP/E Angle Polisher
Article No.: 28660
On our sole responsibility, we declare that this
product conforms to the following directives and
normative documents:
EU Machinery Directive 2006/42/EC
DIN EN 60745-1 / 01.2010
DIN EN 60745-2-3 / 04.2015
EU EMC Directive 2014/30/EC
DIN EN 55014-1 / 05.2012
DIN EN 55014-2 / 02.2016
DIN EN 61000-3-2 / 03.2015
DIN EN 61000-3-3 / 03.2014
Date: 06.02.2018
Jörg Wagner (Dipl.-Ing.)
PROXXON S.A.
The person authorised to compile the technical
documents is identical to the signatory
To Next Page
Loading...
