Need help?Do you have a question about the Prusa Original Prusa i3 MK3 and is the answer not in the manual?
Detailed steps for flashing firmware using Slic3r PE on Windows.
Step-by-step process to load all five filaments into the MMU2 unit.
Procedure for loading individual filaments using the printer's LCD menu.
Method for loading filaments using the MMU unit's physical buttons.
Steps to calibrate the printer's Z-axis after MMU2 installation.
Procedure for calibrating the first layer for optimal print adhesion.
Setting purge volumes to manage filament waste and color contamination.
General| Print Technology | Fused Deposition Modeling (FDM) |
|---|---|
| Build Volume | 250 x 210 x 210 mm |
| Layer Height | 0.05 - 0.35 mm |
| Filament Diameter | 1.75 mm |
| Max Print Speed | 200 mm/s |
| Max Nozzle Temperature | 300°C |
| Max Bed Temperature | 120°C |
| Extruder Type | Direct Drive |
| Power Supply | 240W |
| Firmware | Prusa Firmware (based on Marlin) |
| Weight | 7 kg |
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, SD card |
| Frame Material | Aluminum |
| Supported Materials | PLA, ABS, PETG, Nylon |
| Bed Type | Heated |
| Bed Leveling | Automatic |
To Next Page
