Pruveeo MX2 - Button Functions; Power, Menu, and Mode Buttons

© 2018 PRUVEEO All Rights Re s er v ed .
12
Button
Functions
1
Power
* There is no built-in battery, please connect to the power cord to
turn on this dash cam.
* Press to turn the screen on / off.
2
Menu
* In standby mode, press ONE / TWICE to enter settings, press
again to EXIT.
3
Mode
Switching
/
Photo
Shooting
* Press and hold for about 3 seconds to switch between Recording
/ Playback modes.
* In Playback mode, press this button to playback / stop video.
* In Standby mode, press the button to switch to Photo Mode,
press again to take photos. Press and hold for about 3 seconds to
quit.
4
Emergency
Locking
/
OK
* Emergency Lock. Press this button to lock the current video
manually during recording.
* Press to confirm a selection while in Setting Mode.
5
Micro SD
Card Slot
Supports Micro SD cards up to 32GB, Class 10 Card is required.
6
Reset
If the dash cam stops working, press and hold this button for
about 7 seconds to reset the dash cam to default settings.