PS Audio P3 - Reboot; Auto Reboot; Network; Host Name

4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
8
®
Operation Guide
©2012 PS Audio International Inc. All rights reserved.
Owner’s Reference P3
The outlet is ALWAYS ON, but may be rebooted through the web interface.
The outlet is ALWAYS ON, may be rebooted from the web interface, and automatically reboots when
no web connection is detected for 10 minutes. When Auto Reboot is selected you may use the on
and off delays to sequence power of all Auto Reboot outlets.
When all desired changes have been made, simply click the Save button at the bottom of the page
to put them into effect.
The nal page available is the Network page. This page allows you to modify the network settings of
your P3 Power Plant. Please exercise extreme caution when modifying any settings on this page as
the incorrect settings will result in loss of network connectivity.
The Host Name can be used to access your P3 by typing a name into your browser rather than the
local IP address. To alter the Host Name type the new name in the text eld. The default host name
for the P3 is POWERPLANT.
The P3 is setup to rely on a DHCP enabled router or switch. Most routers will have DHCP enabled
by default, as does the P3. If you do not have DHCP enabled on your network or wish to set up
your P3 with a static address on the local network you may choose to disable DHCP by removing
the checkbox. In order to maintain network connectivity you must know and input the correct IP
address, gateway, subnet mask, primary DNS and secondary DNS.
When all desired changes have been made, click the ‘Save Cong’ button at the bottom of the page
to update the P3.
Auto Reboot
Network
Host Name
Enable DHCP
Reboot