Control & Operation
®
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 | service@psaudio.com | www.psaudio.com
15-042-21-1 Rev A
Instruction i
©2010 PS Audio International Inc. All rights reserved.
Filter 1 MP APOD
4PUPT\TWOHZL(WVKPZPUNÄS[LY3V^WYLYPUNPUNTPUPTHS
group delay, minimized post ringing, good phase vs. frequency,
ZOHYWLYÄS[LYJ\[VMM
Filter 2 MP SOFT
4PUPT\TWOHZLZVM[RULLÄS[LY3V^WYLYPUNPUNTPUPTHSNYV\W
delay, minimized post ringing, good phase vs. frequency, soft
cutoff.
Filter 3 LP APOD
3PULHYWOHZL(WVKPZPUNÄS[LY5VNYV\WKLSH`WLYMLJ[WOHZL]Z
MYLX\LUJ`TPUPTHSWVZ[YPUNPUNZVTLWYLYPUNPUNZOHYWLYÄS[LY
cutoff.
Filter 4 LP SOFT
3PULHYWOHZLZVM[RULLÄS[LY5VNYV\WKLSH`WLYMLJ[WOHZL]Z
MYLX\LUJ`TPUPTHSWVZ[YPUNPUNZVTLWYLYPUNPUNZVM[LYÄS[LY
cutoff.
Filter 5 MP 1/2B
4PUPT\TWOHZLYLJ\YZP]L/HSM)HUKZ`TTL[YPJHSÄS[LY
Minimized pre and post ringing, good group delay, good phase
vs. frequency response, sharp cutoff.
Phase (Polarity)
Touching this control on the front panel touch screen (or the
remote) will invert the absolute phase (polarity) of the audio
signal. This is the same thing as reversing the loudspeaker
inputs, placing + to – and – to +. Phase reversal happens on
many recordings, sometimes even within the same CD or DVD.
If the track sounds a little “off” try reversing the phase with this
control to see if the CD track gains a bit of proper perspective. If
it does, chances are good that it was recorded out of polarity.
Owner’s Reference
Perfect Wave DAC