7
7. Valve Mounting
7.1 PSL201-214
Note: The pictures below show the mounting of a PSL204. The steps are identical for all types.
When mounting the actuator onto the valve, use the handwheel and do not drive the
actuator electrically.
If these instructions are not observed, it may result in personal injury or damage to the
actuator and/or valve.
FOR MOUNTING THE ACTUATOR, THE VALVE MUST BE IN FULLY CLOSED POSITION!
Pillar
Clamping screws for
spring pack
Valve stem
Lockin
nut
Coupling
Coupling nut
Pillar nut
Bracket
①
Make sure that the
coupling nut can be turned
by hand
②
Drive coupling completely
upwards by hand
③
Put actuator onto valve
To Next Page
Loading...