9.5 ONLINE CONTROL
Online control serves for operation of the PolyPen device in SpectraPen software after the connection with PC.
The measurement, changes in settings and measurement repetition can be set through online control.
Go to Device > Online Control in SpectraPen software.
Fig. 27 Online Control
Reflectance/Absorbance
You can use button Get for obtaining the reference information (Fig. 27-1) and button Get for immediate
measurement (Fig. 27-2) of reflectance or absorbance. In online control can be set measurement repetition. Click
to button … (Fig. 27-3), select Use settings (Fig. 27-4), fill the pause between the measurement in seconds (Fig.
27-5) and confirm it by button OK (Fig. 27-6). Measured data can be exported to the .csv file by button Export
placed under the reflectance scope or be deleted by button Clear.
Fig. 27 Setting of reflectance or absorbance measurements in online control
Settings
Time synchronization with computer time (Fig. 28-1).
Device > Online Control > Settings > Sync > OK
GPS – After GPS module is enabled, it begins acquiring satellite signals. Exported data then has GPS
coordinates mark (Fig. 28-2).
Average – Average function is used for adjusting the number of scans for each reading (Fig. 28-3).
To Next Page
Loading...
Need help?
General
