Need help?Do you have a question about the PTF 3203A and is the answer not in the manual?
Detailed explanation of the ptf 3203A receiver architecture, GPS receiver input, and components.
Explanation of how the internal oscillator is disciplined by the GPS signal for frequency accuracy.
Details on receiver architecture, acquisition time, time and position accuracy, and dynamic characteristics.
Specifications for standard outputs including 10MHz sine wave, 1 PPS, and IRIG B (AM).
Defines the pulse rate, amplitude, and duty cycle for the J4 programmable output.
Specifies the pulse rate, amplitude, pulse width, and trigger for the J5 event trigger output.
Details the RS232 serial port for remote monitoring and control of unit functions.
Describes Ethernet interface for remote monitoring, control, and NTP functionality.
Specifies AC and optional DC input voltage and frequency range for the unit.
Provides the physical dimensions of the chassis, including height, width, and depth.
Lists the weight specifications for the chassis and the antenna.
Defines the operating and storage temperature and humidity ranges for the unit.
Details the Network Time Protocol (NTP) version, response types, and accuracy.
Instructions for inspecting the received equipment for damage and initial handling procedures.
Guidance on mounting the unit chassis into a standard 19-inch rack frame.
Critical steps for antenna installation to ensure optimal performance and prevent hazards.
Information on connecting the antenna using the supplied RG-58 coaxial cable.
Instructions for connecting the unit to a standard AC power source.
Describes the standard BNC connectors for timing outputs and optional input/output connectors.
Details connections for RS232 and Ethernet ports for control and monitoring.
Visual representation of standard output/input connections on the rear panel.
Process of initializing the unit, including satellite acquisition and oscillator synchronization.
How to lock and set position information, including survey and fixed positioning modes.
Configuration and command set for controlling and monitoring the unit via RS232.
Placeholder section, no content provided.
Details the command structure and syntax for serial port communication.
Commands for retrieving unit status and controlling servo functions.
Configuration and usage of the Ethernet interface for remote control and monitoring.
Description of various display screens, including initialization, GPS engine, and status.
General information on the low maintenance requirements of the unit.
Details oscillator types (TCXO, OCXO, Rubidium) and aging characteristics.
Specifications and calculations for OCXO oscillator aging and control range.
Specifications and calculations for Rubidium oscillator aging and control range.
Precautions for using the optional front panel keypad and replacement procedures.
Information on the display's MTBF, blanking function, and replacement.
Details on the rechargeable battery for the on-board RAM, including type and caution.
To Next Page
General