PTI security systems VP keypad controls entry - OPERATION: VP Keypad Setup Function; Entering Setup Mode

16 17
opeRation
VP Keypad Setup Function
To enter setup mode:
1. Press the *, 0, and # keys simultaneously
2. Enter the factory password: 8898
3. Press the # key
NOTE: In the event the password is changed and then forgotten, you can
disconnect power from the keypad and then hold the program button while
reconnecting power. This will bypass the password prompt and enter the setup
mode directly. When using this method, you will also be prompted to Restore
Factory Defaults. Select yes to restore all default factory settings including the
site name and password.
Press the # key to advance through each setup parameter. A parameter is
automatically saved when you press # and move to the next parameter. If
the timeout is allowed to occur, the current parameter WILL be saved.
Numeric values are entered directly into the unit using the number keys.
When an option is presented, use the * key to scroll through the available
settings.
There are two (2) ways to exit Setup mode:
• Press the 7, 8, and 9 keys simultaneously
• Go through all of the setup functions
A timeout is built into the system that will exit Setup mode if there is no
input on the keypad for an extended period of time.
Setup Parameters/Functions
Setup parameters in the order displayed by the APEX access device are:
Restore Defaults
*=Yes #=No
This prompt only occurs if the program button is
held while power is applied to the device. Pressing
the * key to select YES will restore all of the factory
defaults. WARNING: This will overwrite all setup
parameters including the setup password and the
site name.
Setup Menus
*=chng #=next
Identies how to use the keys: the * key is used to
change a parameter and the # key is the enter key to
move to the next menu.
Current Add: 001
New(1-127):
Polling address used by the controller. Any number
from 1 to 127 can be entered. The numbers 0 and
22 cannot be used. Each device connected to the
controller must have a unique address. Factory
default is 1.
* to Change Baud:
9600
The communications baud rate used by the controller.
Scroll through the list of available rates by pressing
the * key. Factory default is 9600.