To Next Page
R
Rhonda RoseAug 2, 2025
What to do if the display on the VP Keypad by PTI security systems is blank?
- LLisa MatthewsAug 2, 2025
If the display on the VP Keypad is blank, replace the VP and retest the system.
What to do if the display on the VP Keypad by PTI security systems is blank?
If the display on the VP Keypad is blank, replace the VP and retest the system.
What to do if the voltage at the VP Keypad by PTI security systems, connector P1 pins 1 & 3 is less than 10.5 Volts?
If the voltage at the VP, connector P1 pins 1 & 3 is less than 10.5 Volts, check the power supply and wiring, then retest.
What to do if other devices are set to the same address as the VP Keypad by PTI security systems?
If other devices are set to the same address as the VP, change the address of one of the devices and then retest the system.
General| Category | Keypad |
|---|---|
| Manufacturer | PTI Security Systems |
| Function | Controls entry |
| Operating Voltage | 12V DC |
| Operating Temperature | -4° to 158° F |
Details the voltage and current consumption requirements for the VP keypad.
Specifies the maximum switching voltage, current, and capacity for relay outputs.
Specifies keypad mounting height for wheelchair access from the front.
Defines keypad mounting height for wheelchair access from the side.
Advises on power and data communication wiring for VP devices.
Instructions for opening the keypad and mounting the back plate securely.
Guidance on pulling necessary wires through the housing and allowing slack.
Procedures for stripping cables and removing terminal blocks from the circuit board.
Steps for inserting wires into terminal slots and tightening screws.
Details connections for power, data, and ground on Terminal Block P1.
Explains relay connections on P2 and earth ground wire requirements.
Instructions for connecting gate operators and presence sensors.
Procedures to test the display, backlight, and touchpad functionality.
Steps to verify communication between the keypad and the controller.
Steps to enter the keypad's setup mode using the factory password.
