Z
T-937S lead-free reflow oven user manual
9
/
9
6) Press”Constant Temp Timing”,enter into below interface.That’s function is for setting Constant Temp
state.
7) The buzzer will ring when the soldering finishes.
Special note:
In the cooling stage of reflow welding process, if the actual temperature is higher
than the preset temperature of 15℃, the motherboard will send out a beeping prompt, which is
a normal phenomenon.
8) The system version is subject to change without prior notice.
6.Attention
1) Ensure the machine is grounded reliably.
2) Please connect the exhaust pipe to the outdoor ventilation place or recovery device to avoid indoor
pollution.
3) The thermal insulation material of the machine has been strictly protected, it is not allowed to
disassemble the machine without protection.
4) You should reserve more than 10s time interval between last turning off and next turning on, It cannot be
turned on / off continuously.
7.Warranty
The whole machine’s warranty is one year, with lifelong maintenance, long-term Ex-factory price supply
accessories, we provide instant online Q &A , technical consulting services.
Declaration
If there is any inconsistency between user manual and actual product, the actual product shall prevail.
Edit Red “data” to set
“Constant Temp”
To Previous Page
