LED New Light Source Reflow Oven T-960
temperature fine-turning.
6. The heat temperature wave is adjustable according to the PCB board. You can adjust
the transmission belt speed to adjust the temperature. Reduce the belt spend can
increase the product heat temperature. On the contrary, you can reduce the product
heat temperature.
7. Attention: if there is components on the PCB, the PCB pass the reflow and it reflow
not very completely, suggest you adjust then reflow again. Usually this cannot damage
the components.
8. From low to high when set temperature. If the heat range is over the reflow
temperature too high, should increase the transmission speed or reduce the set
temperature. The detailed operation is opposite to step 4.
Equipment Installation
1. Set up field.
1.1. Please do the work in the clean environment condition.
1.2. Do not put the machine near the electromagnetism interfering resource.
1.3. Do not put the oven exits and entrances face towards to the fan and the window.
2. Power supply
Please use five-wire system380V. Ensure the machine contacts the earth well and
requested professional electrician operation.
3. Adjust the reflow oven height.
By adjust the machine leg to adjust the height. The way is follow: use industrial or
alcohol gradienter to measure. Then adjust the machine leg to adjust the dryer on all
To Next Page
Loading...
