Save For Future Reference
This floor machine is a high quality, precision made product. All parts used in the manufac-
turing of this machine have passed rigid quality control standards prior to assembly and an
“each unit” final inspection prior to packaging is your assurance of proper assembly. This
machine was protectively packed to prevent possible damage in transit. Should damage
occur,please notify the transporting carrier immediately for loss and/or claim.
Floor Machine
MOTOR:
Be sure your power supply agrees with the voltage marked on name
plates. Voltage decreases of more than 10% can cause the motor to
burn out.
Note: This floor machine is for commercial use.
IMPORTANT SAFEGUARDS
EXTENSION CORDS:
Machines that have 3 wire cords requiring grounding must only be
used with extension cords that have 3-prong grounding type plugs
and 3-pole receptacles.
To determine the minimum wire size required, refer to the chart
below:
Minimum Wire Size (AWG) of Extension Cord
Nameplate Total Extension Cord Length (Feet)
Rating-Amps 25 50 75 100 125 150 175 200
0-10.0 18 18 16 16 14 14 12 12
10.1-13.0 16 16 14 14 14 12 12 12
13.1-15.0 12 12 12 12 12 12 12 –
Before using an extension cord,inspect it for loose or exposed wires,
damaged insulation and defective fitting.
NOTE: Warranty claims will be honored ONLY if handled by an autho-
rized Pullman-Holt Service Center unless other prior arrangements
have been made with the Pullman-Holt Service Department.
Operation & Care Instructions
WARNING
Risk of explosion. Floor sanding can result in an explosive
mixture of fine dust and air. Use floor-sanding machine
only in a well ventilated area free from any flame or match.
WARNING
RISK OF FIRE: Do not use with a flammable or combustible
liquid to clean a floor.
WARNING
OF POTENTIAL INJURY: Moving parts – to reduce the
risk of injury, unplug before servicing.
This appliance must be grounded. If it should malfunction or
breakdown, grounding provides a path of least resistance for elec-
tric current to reduce the risk of electric shock. This appliance is
equipped with a cord having equipment grounding conductor and
grounding plug. The plug must be inserted into an appropriate out-
let that is properly installed and grounded in accordance with all
local codes and ordinances.
WARNING
Improper connection of the equipment grounding conductor
can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to weather
the outlet is properly grounded.
Do not modify the plug provided with the appliance – if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
This appliance is for use on a nominal 120- Volt circuit, and has a
grounded plug that looks like the plug illustrated in sketch A below.
A temporary adapter that looks like the adapter illustrated in
sketches B and C may be used to connect this plug to a 2-pole
receptacle as shown in sketch B if a properly grounded receptacle
is not available. The temporary adapter should be used only until a
properly grounded outlet (sketch A) can be installed by a qualified
electrician. The green colored ear, lug,or the like extending from
the adapter must be connected to a permanent ground such as a
properly grounded outlet box cover. Whenever the adapter is used,
it must be held in place by a metal screw.
NOTE: In Canada, the use of a temporary adapter is not permitted
by the Canadian Electrical Code.
GROUNDING INSTRUCTIONS
To Next Page
Need help?
General
