Puls CD Series - Connection Terminals

CD10.241
CD-Series
DC/DC Converter 24V/24V, 10A, 240W
Sep. 2019 / Rev. 1.4 DS-CD10.241-EN All values are typical figures specified at 24Vdc input voltage 24V, 10A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
12/27
11. C
ONNECTION
T
ERMINALS
The terminals are IP20 Finger safe constructed and suitable for field- and factory wiring.
Input Output
Type
Screw terminals Screw terminals
Solid wire
Max. 6mm
2
Max. 6mm
2
Stranded wire
Max. 4mm
2
Max. 4mm
2
American Wire Gauge
20-10 AWG 20-10 AWG
Max. wire diameter (including ferrules)
2.8mm 2.8mm
Recommended tightening torq
ue 1Nm, 9lb.in 1Nm, 9lb.in
Wire stripping length
7mm / 0.28inch 7mm / 0.28inch
Screwdriver
3.5mm slotted or Phillips No 1 3.5mm slotted or Phillips No 1
Daisy chaining of outputs:
Daisy chaining (jumping from one DC/DC-converter output to the next) is allowed as long as the average output
current through one terminal pin does not exceed 25A. If the current is higher, use a separate distribution terminal
block.
Fig. 11-1 Daisy chaining of outputs Fig. 11-2 Using distribution terminals
DC/DC
Converter
+ + - -
Input
Output
Load
+ -
max 25A!
DC/DC
Converter
+ + - -
Input
Output
Load
+ -
Distribution
Terminals
DC/DC
Converter
+ +
- -
Input
Output
DC/DC
Converter
+ +
- -
Input
Output