Pulsar AS 150 User Manual

3. Clock Reset :
• Digital clock indicates time in HR & MM separated
by colon ‘:’
• It is a 12 hour clock.
• Initially ‘:’ will be blinking
• Clock setting is possible in TRIP 1 mode only.
1.
Press 'Mode' push button
for less than 2 sec.
TRIP1 Mode selected
2.
Press 'Mode' & 'Set'
push button together
for more than 2 sec.
Press 'Mode' button for
less than 1 sec.
Press 'Set' button for
less than 1 sec.
Press 'Mode' & 'Set'
button together for
more than 2 sec.
Clock set 'Mode' is
selected & no editing
is carried out for
more than 5 sec.
or
Vehicle is started.
‘:’ stops blinking
Digits start blinking
Hour digits will
increase by one.
Minute digits will
increase. If Mode/Set
button is pressed
continuously then digits
will stop blinking.
Set value will be saved
Exit clock setting mode
Digits stop blinking
‘:’ start blinking
Auto exit without saving
set value.
3.
4.
5.
6.
Speedometer Setting
12
M
S
Mode
TRIP1/2
Set

Pulsar AS 150 Specifications

General

Displacement	149.5 cc
Fuel System	Carburetor
Fuel Tank Capacity	15 L
Compression Ratio	9.5:1
Frame Type	Double Cradle
Max Torque	13.4 Nm @ 6000 rpm
Transmission	5 Speed
Front Suspension	Telescopic
Front Brake	Disc
Rear Brake	Drum
Clutch	Wet Multiplate