X
6
7
The attachment was designed for extensive usage. To ensure longevity and
performance, please adhere to the following:
A
B
C
D
E
F
G
H
J
K
L
M
N
O
P
Q
X=00 Y=00 00 00
AM
IR IR
IR
B
A
C D E F G H
J K L M QN
O
P
Reticle movement directions
Reticle's X and Y coordinates
Contrast mode
“Sum Light™” mode
Adjustment of display brightness
and contrast
Clock
Low battery indicator
Clock setup mode
Indication for IR Illuminator power level
Horizon adjustment function
Indication for external power supply
Aiming point adjustment mode
Indication of activation of wireless remote control
Limiting frame
Auxiliary cross
PAL/NTSC video output signal selection
• Before use make sure that you have installed the attachment according
to the instructions of the section 8 “Operation”.
• Store with the lens cap on in the carrying case.
• Switch off the unit after use.
• The unit cannot be submerged in water.
• Attempts to disassemble or repair the scope will void the warranty!
• Clean the scope's optical surfaces only if necessary, and use caution.
First, remove (by blowing with a blower brush or canned air) any dust or
sand particles. Then proceed to clean by using camera/lens cleaning
equipment approved for use with multicoated lenses. Do not pour the
solution directly onto the lens!
• The riflescope can be used in operating temperatures ranging from
-20 °C... +50 °C. However, if it has been brought indoors from cold
temperatures, do not turn it on for 3 to 4 hours. This will prevent external
optical surfaces from fogging.
• To ensure reliable performance, it is recommended to carry out regular
technical inspections of the unit.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
• Turn the lever of the battery compartment (8) 90 degrees in “Open”
position and, pulling by the lug of the cover, remove the battery container.
• Install four AA batteries (or rechargeable batteries) observing marking
shown on the battery container.
• Insert the battery container into the battery compartment observing
polarity and turn the lever 90 degrees clockwise .
Note: to ensure long and reliable operation it is recommended that you use
quality rechargeable batteries with a capacity of at least 2500 mAh. Please
do not use batteries of different types or batteries with various charge
levels.
• The scope can be powered with an external DC power supply
(2.1mm pin) with stabilised voltage ranging from 8.4V to 15V
or a 12V vehicle socket.
To Next Page
Loading...