Pulsar KRYPTON 2 - Page 21

 Loosen the screw  14  with an Allen key  S = 4 mm ).
 Turn on the attachment by briefly pressing the ON / OFF 8  button .
 Align the display center with the crosshairs of the reticle by tilting the attachment .
You can activate the auxiliary cross on the display in the “ Display
Alignment ” section of the main menu .
 Tighten the screw  14  as far as it will go . The clamping force should be 5 N · m
44.3 in - lbs ) ( use the torque screwdriver to check ).
 Move the lever  17 to the OPEN  position .
 Align top and bottom display boundaries parallel to the horizontal axis of the optical
sight by turning the attachment clockwise or counterclockwise .