Pulsar KRYPTON - Page 21

17. Align top and bottom display boundaries parallel to the horizontal axis of the
riflescope by turning the attachment clockwise or counterclockwise .
18. Having reached the best possible position of the attachment , tighten two screws 16
until stop . The clamping force should be 6.57.5 N · m ( use a torque screwdriver to
check ).
Selection table for riflescope inserts
Ring
Adapter
model
The internal diameter of the insert needs to match the outer diameter of the
objective lens housing of the daylight riflescope it is being installed on
Insert internal
diameter , mm
Suitable for lens housing of daylight riflescope with an
outer diameter of , mm
PSP Ring
Adapter 42
mm
45.5 45.5
46 46
46.5 46.5
47 46.747.6
48 47.7 48.6
49 48.749.6
50 49.750.6
PSP Ring
Adapter 50
mm
51.6 51.6
53.4 53.4
55 54.755.6
56 55.756.6
57 56.757.6
58 57.758.6
59 58.759.6